Grass-valley TTN-BTS-1616/34 User Manual

MANUAL PART NO. 04-052070-004 Rev. 2MARCH 19, 2003 INSTALLATION MANUAL TRITON routing switcher Telecom Data Router 16x16 34/45 Mbps Product model no.

BTS-1616/34 Rev. 2 2 1.2 Connection drawing Input section Router Output section NCB1 Power connectors RS-232

BTS-1616/34 Rev. 2 3 2 Power connection Do not connect mains to the desktop power supply before connecting the power supply to the router.

BTS-1616/34 Rev. 2 4 3 Connecting the BTS-1616/34 to your PC For connection to a PC with Triton Router Control System, the RS-232 interface is

BTS-1616/34 Rev. 2 5 4 NCB connection Via the Network Control Bus system several routers and control panels can be interconnected. The stand

BTS-1616/34 Rev. 2 6 4.3 Pin-out and cable type 4.3.1 RJ45 connectors On some Triton devices, the NCB cable can be connected to RJ-45 connector

BTS-1616/34 Rev. 2 7 4.3.3 RJ45 to 5-pin DIN converter In configurations that include both devices with RJ45 connectors, and devices with 5-

BTS-1616/34 Rev. 2 8 o RS-422 Data + CP for data on Level 3 o Universal Control Panel to control all devices above, with user configurable defau

BTS-1616/34 Rev. 2 9 5 Router configuration 5.1 Router level Switches 1 - 4 on the configuration switch set the router’s level for communicat

BTS-1616/34 Rev. 2 10 5.4 Power up mode Switch 8 on the configuration switch defines the power up mode. The BTS-1616/34 router provides two mode

BTS-1616/34 Rev. 2 11 7 Control and connection of Triton systems, interface protocol 7.1 Important notes regarding the Triton Control Proto

ii Headquarters Thomson Broadcast Systems 17 rue du Petit Albi - BP 8244 95801 Cergy Pontoise Cedex FRANCE Thomson Broadcast and Media Solutions, Inc

BTS-1616/34 Rev. 2 12 7.2.2 Example: Several units connected by NCB Messages sent to the RS232 of a single unit will be returned once no matter w

BTS-1616/34 Rev. 2 13 7.5 Commands 7.5.1 Audio crosspoint set Only for use with Audio routers. Command for setting of crosspoints: 10

BTS-1616/34 Rev. 2 14 7.5.4 Video crosspoint set acknowledge Only for use with Video routers. Command for acknowledging setting of crosspoints:

iiiContents Electromagnetic Radiation Notice v Hardware Warranty and Software License vi Parts and Service vi Revision history vii 1 Gener

iv 7.2.1 Example: A single unit with no NCB connected 11 7.2.2 Example: Several units connected by NCB 12 7.3 RS232 12 7.4 NCB 12 7.5 Comma

vElectromagnetic Radiation Notice The following information is given to note compliance with the United States Government Federal Communications Co

vi Hardware Warranty and Software License Please contact your local Thomson representative for hardware warranty and software license information.

vii Revision history Current revision of this document is the uppermost in the table below. Revision Replaces Date Change Description 2

BTS-1616/34 Rev. 2 1 1 General The BTS-1616/34 is a 16x16 telecom router for 34Mbit/s or 45Mbit/s data rate. BTS-1616/34 meets ITU-T G.703 fo